Honda CR-V: Navigation System
Honda CR-V (2006–2011) Service Manual / Audio, Navigation,
and Telematics / Navigation System
Component Location Index
- GPS ANTENNA
- Removal/Installation
- NAVIGATION
MICROPHONE
(Inside the map light)
- Replacement
- NAVIGATION UNIT
- Removal/Installation
- REARVIEW CAMERA
- Removal/Installation
- VOICE CONTROL SWITCH
- Test
- Replacement
- PCM
- General Troubleshooting Information
- System Description
- Symptom Troubleshooting
- System Diagnostic Mode
- CD, DVD, and PC Card Removal/Installation
- Navigation Unit Removal/Installation
READ NEXT:
General Troubleshooting Information
General Operation
Refer to the navigation system manual, for the
navigation system operating procedures.
Anti-theft Feature
The navigation system has a coded theft protection
circuit. Make sure you ha
System Description
Overview
The navigation system is a highly sophisticated, hybrid locating system.
The navigation unit uses global positioning system (GPS) satellite signals,
internal yaw and vehicle speed inputs, a
Symptom Troubleshooting
No picture is displayed
NOTE: Always check the connectors for poor
connections or loose terminals between the audio unit,
audio disc changer, navigation unit, and XM receiver.
1. Check the No. 23 (10
SEE MORE:
Heater Unit/Core
Replacement
SRS components are located in this area. Review the
SRS component locations, and the
precautions and procedures before
doing repairs or service.
1. Make sure you have anti-theft codes for the audio
system and the navigation system (if equipped).
2. Make sure the ignition is OFF, then disconnect the
DTC P0325: Knock Sensor Circuit Malfunction
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine. Hold the engine speed between
3,000 rpm without load (in Park or neutral) u
© 2016-2025 Copyright www.hcrv.net
