Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC 11, 13, 15, 17: Wheel Sensor (Open/Short to Body Ground/Short to Power)

1. Turn the ignition switch ON (II). 2. Check for DTCs with the HDS. Is DTC 87 indicated with DTC 11,13,15, and/or 17 at the same time? YES-Go to step 9. NO-Go to step 3. 3. Clear the DTC with the

 DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)

NOTE: If the ABS and other indicators come on because of electrical noise, the indicators will go off when you test-drive the vehicle at 10 mph (15 km/h) or more and noise is gone. An incorrectl

 DTC 51: Motor Locked

1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Test-drive the vehicle. Drive the vehicle at 10 mph (15 km/h) or more, with the engine speed at 2,500 rpm or more. 4. Check fo

SEE MORE:

 Driveline/Axle

Special Tools Oil Seal Driver Attachment, 52 x 55 mm Half Shaft Base Threaded Adapter, 24 x 1.5 mm Threaded Adapter, 26 x 1.5 mm Attachment, 35 mm I.D. Driver Inner Handle, 30 mm Oil Seal Driver Component Location Index BOOT BAND Removal Installation INTERMEDIATE SHAFT Rem

 Modifying Your Vehicle

Removing parts from your vehicle, or replacing components, with non-Honda components could seriously affect your vehicle’s handling, stability, and reliability. Here are some examples: Lowering the vehicle with a non- Honda suspension kit that significantly reduces ground clearance

© 2016-2025 Copyright www.hcrv.net