Honda CR-V: Navigation System
Honda CR-V (2006–2011) Service Manual / Audio, Navigation,
and Telematics / Navigation System
Component Location Index
- GPS ANTENNA
- Removal/Installation
- NAVIGATION
MICROPHONE
(Inside the map light)
- Replacement
- NAVIGATION UNIT
- Removal/Installation
- REARVIEW CAMERA
- Removal/Installation
- VOICE CONTROL SWITCH
- Test
- Replacement
- PCM
- General Troubleshooting Information
- System Description
- Symptom Troubleshooting
- System Diagnostic Mode
- CD, DVD, and PC Card Removal/Installation
- Navigation Unit Removal/Installation
READ NEXT:
General Troubleshooting Information
General Operation
Refer to the navigation system manual, for the
navigation system operating procedures.
Anti-theft Feature
The navigation system has a coded theft protection
circuit. Make sure you ha
System Description
Overview
The navigation system is a highly sophisticated, hybrid locating system.
The navigation unit uses global positioning system (GPS) satellite signals,
internal yaw and vehicle speed inputs, a
Symptom Troubleshooting
No picture is displayed
NOTE: Always check the connectors for poor
connections or loose terminals between the audio unit,
audio disc changer, navigation unit, and XM receiver.
1. Check the No. 23 (10
SEE MORE:
Symptom Troubleshooting
SRS indicator does not come on
1. Connect the HDS to the DLC.
2. Turn the ignition switch ON (II).
3. Make sure the HDS communicates with the vehicle and the SRS unit. If it does
not communicate, troubleshoot the DLC circuit.
4. Check for PGM-FI, Body Electrical, and SRS DTCs
with the HDS.
Are
Front Driveshaft Installation
1. Apply grease to the contact area (A) of the outboard
joint and front wheel bearing.
NOTE: Failure to apply grease may cause excessive
noise and vibration.
2. Install a new set ring (A) onto the set ring groove
(B) of the driveshaft (left driveshaft).
3. Apply 0.5-1.0 g (0.02-0.04 oz) of grease
© 2016-2025 Copyright www.hcrv.net
