Honda CR-V: DTC Troubleshooting
Honda CR-V (2006–2011) Service Manual / Brakes / VSA (Vehicle Stability Assist) System Components / DTC Troubleshooting
- DTC 11, 13, 15, 17: Wheel Sensor (Open/Short to Body Ground/Short to Power)
- DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)
- DTC 51: Motor Locked
- DTC 86: F-CAN Communication
- DTC 91: VSA System
READ NEXT:
DTC 11, 13, 15, 17: Wheel Sensor (Open/Short
to Body Ground/Short to Power)
1. Turn the ignition switch ON (II).
2. Check for DTCs with the HDS.
Is DTC 87 indicated with DTC 11,13,15, and/or 17
at the same time?
YES-Go to step 9.
NO-Go to step 3.
3. Clear the DTC with the
DTC 12, 14, 16, 18: Wheel Sensor (Electrical
Noise/Intermittent Interruption)
NOTE:
If the ABS and other indicators come on because of
electrical noise, the indicators will go off when you
test-drive the vehicle at 10 mph (15 km/h) or more
and noise is gone.
An incorrectl
DTC 51: Motor Locked
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Test-drive the vehicle. Drive the vehicle at 10 mph
(15 km/h) or more, with the engine speed at
2,500 rpm or more.
4. Check fo
SEE MORE:
DTC Troubleshooting
DTC B1000: Communication Bus Line Error
(Bus-off)
1. Clear the DTCs with the HDS.
2. Turn the ignition switch OFF, and then back ON (II).
3. Wait for 6 seconds or more.
4. Check for DTCs with the HDS.
Is DTCs B1000 and/or B1008 and B1011
indicated?
YES-Go to step 5.
NO-Intermittent failure, the
System Description
Headlights System Description
The headlight system is composed of the MICU, the headlight and
dimmer/flash-to-pass switches (inside the
combination light switch), the left and right headlights, and the high beam
indicator.
The MICU controls the headlights with a built-in low beam headlight relay
© 2016-2025 Copyright www.hcrv.net
