Honda CR-V: Odometer

The odometer shows the total distance your vehicle has been driven. It measures miles in U.S.

models and kilometers in Canadian models. It is illegal under U.S.

federal law and Canadian provincial/ territorial regulations to disconnect, reset, or alter the odometer with the intent to change the number of miles or kilometers indicated.

READ NEXT:

 Fuel Gauge

This shows how much fuel you have. It may show slightly more or less than the actual amount. Avoid driving with an extremely low f uel level. Running out of f uel could cause the engine to

 Temperature Gauge

This shows the temperature of the engine’s coolant. During normal operation, the reading should be in the middle of the gauge. In severe driving conditions, such as very hot weather or a l

 Outside Temperature Indicator

If equipped This indicator displays the outside temperature in Fahrenheit (U.S. models) or Celsius (Canadian models). The temperature sensor is in the front bumper. Therefore, the tempe

SEE MORE:

 DTC P0107: Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage Input

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Clear the DTC with the HDS. 2. Turn the ignition switch OFF, then turn it ON (II) again. 3. Check whether DTC P0107 is indicated in the DTCs/ Freeze Data in PGM-FI M

 Front Driveshaft Installation

1. Apply grease to the contact area (A) of the outboard joint and front wheel bearing. NOTE: Failure to apply grease may cause excessive noise and vibration. 2. Install a new set ring (A) onto the set ring groove (B) of the driveshaft (left driveshaft). 3. Apply 0.5-1.0 g (0.02-0.04 oz) of grease

© 2016-2024 Copyright www.hcrv.net