Honda CR-V: DTC Troubleshooting
- DTC P0107: Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage Input
- DTC P0705: Short in Transmission Range Switch Circuit (Multiple Shift-Position Input)
- DTC P0706: Open in Transmission Range Switch Circuit
- DTC P0712: Short in ATF Temperature Sensor Circuit
- DTC P0716: Problem in Input Shaft (Mainshaft) Speed Sensor Circuit
- DTC P0721: Problem in Output Shaft (Countershaft) Speed Sensor Circuit
- DTC P0731: Problem in 1st Clutch and 1st Clutch Hydraulic Circuit
- DTC P0752: Shift Solenoid Valve A Stuck ON
- DTC P0776: A/T Clutch Pressure Control Solenoid Valve B Stuck OFF
- DTC P0962: Problem in A/T Clutch Pressure Control Solenoid Valve A Circuit
- DTC P0973: Short in Shift Solenoid Valve A Circuit
- DTC P16CO: PCM A/T Control System Incomplete Update
- DTC P2122: Accelerator Pedal Position (APP) Sensor A (Throttle Position Sensor D) Circuit Low Voltage Input
READ NEXT:
DTC P0107: Manifold Absolute Pressure
(MAP) Sensor Circuit Low Voltage Input
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
1. Clear the DTC with the HDS.
2. Turn the ignition switch OFF, then
DTC P0705: Short in Transmission Range
Switch Circuit (Multiple Shift-Position Input)
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
This code is caused by an electrical circuit problem
and cannot b
DTC P0706: Open in Transmission Range
Switch Circuit
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
This code is caused by an electrical circuit problem
and cannot b
SEE MORE:
Warranty Coverages
U.S. Owners
Your new vehicle is covered by these
warranties:
New Vehicle Limited Warranty - covers your new vehicle, except for
the battery, emissions control
systems, and accessories against
defects in materials and
workmanship.
Emissions Control Systems Defects
Warranty and Emission
To Stop Playing a Disc
Press the eject button (
) to
remove the disc. If you eject the disc,
but do not remove it from the slot,
the system will automatically reload
the disc after 10 seconds and put it in
pause mode. To begin playing, press
the CD/AUX button.
You can also eject the disc when the
igniti
© 2016-2026 Copyright www.hcrv.net
