Honda CR-V: Rear Differential

Special Tools

Honda CR-V. Rear Differential

Honda CR-V. Rear Differential

  1. Holder Handle
  2. Oil Seal Driver
  3. Attachment, 78 x 80 mm
  4. Attachment, 52 x 55 mm
  5. Companion Flange Holder
  6. Driver

Component Location Index

Honda CR-V. Rear Differential

READ NEXT:

 System Description

Outline The rear differential has a real-time 4WD control mechanism that enables 4WD by transmitting appropriate driving force from the front wheels to the rear wheels when necessary. It uses a real

 Dual Pump System Function Test

Starting and accelerating in forward gears (4WD mode) NOTE: Do not test repeatedly or the fluid will overheat. 1. Lift up the vehicle so all four wheels are off the ground. 2. Make a mark (A) on eit

 Rear Differential Fluid Inspection and Replacement

1. With the vehicle on level ground, inspect the differential fluid with the ignition switch turned to LOCK (0). 2. Use solvent and a brush to wash off any oil and dirt from the differential fluid in

SEE MORE:

 XM radio display is blank and no station information is displayed

1. Disconnect audio disc changer 13P connector. 2. Turn the ignition switch to ACC (I). 3. Operate the XM radio, and check the display. Is XM information displayed? YES-Replace the audio disc changer. NO-Go to step 4. 4. Check the No. 34 (7.5 A) fuse in the under-dash fuse/relay box and the No.

 Front Driveshaft Reassembly

Exploded View NOTE: Refer to the Exploded View as needed during this procedure. Inboard Joint Side 1. Wrap the splines with vinyl tape (A) to prevent damaging to the inboard boot. 2. Install the inboard boot onto the drives haft, then remove the vinyl tape. Be careful not to damage the inboard boo

© 2016-2026 Copyright www.hcrv.net