Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0107: Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage Input

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Clear the DTC with the HDS. 2. Turn the ignition switch OFF, then

 DTC P0705: Short in Transmission Range Switch Circuit (Multiple Shift-Position Input)

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot b

 DTC P0706: Open in Transmission Range Switch Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot b

SEE MORE:

 Moonroof

Component Location Index GLASS DRAIN CHANNEL SUNSHADE CABLE ASSEMBLY CABLE TUBE REAR BRACKET MOTOR WIND DEFLECTOR REAR DRAIN TUBE REAR DRAIN VALVE FRAME CLIP FRONT DRAIN VALVE FRONT DRAIN TUBE Symptom Troubleshooting Index Glass Position Adjustment The roof panel (A) should be ev

 Ignition Switch

The ignition switch has four positions: LOCK (0), ACCESSORY (I), ON (II), and START (III). LOCK (0) - You can insert or remove the key only in this position. To turn the key, the shift lever must be in Park, and you must push the key in slightly. If the front wheels are turned, the

© 2016-2026 Copyright www.hcrv.net