Honda CR-V: Symptom Troubleshooting

READ NEXT:

 Poor AM or FM radio reception or interference (with navigation)

NOTE: Check the radio reception in an open area. Compare it to a known-good vehicle of the same model, year, and trim level whenever possible. If necessary, have the customer demonstrate the sym

 Power switch will not turn ON (No information display and no sound) (with navigation)

1. With the ignition switch ON (II), push the power switch ON to see if navigation unit turns ON. Does the navigation unit display operate properly, and does the audio sound normal? YES-Intermittent

 No sound is heard from speaker(s) (display is normal) (with navigation)

NOTE: Set the fader and balance positions to the center. Before doing symptom troubleshooting, do the power switch will not turn ON troubleshooting. 1. Check that the volume button is not set to

SEE MORE:

 DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)

NOTE: If the ABS and other indicators come on because of electrical noise, the indicators will go off when you test-drive the vehicle at 10 mph (15 km/h) or more and noise is gone. An incorrectly installed wheel bearing can cause one of these DTCs. 1. Turn the ignition switch OFF. 2. Check

 Fenderwell

Front Inner Fender Replacement NOTE: Take care not to scratch the body. 1. Remove the front wheel arch protector, as needed. 2. Remove the front inner fender (A). Remove the screws (B, C), and remove the bolt (D) securing the front bumper (E) and front inner fender. Remove the clips (F, G) sec

© 2016-2025 Copyright www.hcrv.net