Honda CR-V: DTC Troubleshooting
Honda CR-V (2006–2011) Service Manual / Brakes / VSA (Vehicle Stability Assist) System Components / DTC Troubleshooting
- DTC 11, 13, 15, 17: Wheel Sensor (Open/Short to Body Ground/Short to Power)
- DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)
- DTC 51: Motor Locked
- DTC 86: F-CAN Communication
- DTC 91: VSA System
READ NEXT:
DTC 11, 13, 15, 17: Wheel Sensor (Open/Short
to Body Ground/Short to Power)
1. Turn the ignition switch ON (II).
2. Check for DTCs with the HDS.
Is DTC 87 indicated with DTC 11,13,15, and/or 17
at the same time?
YES-Go to step 9.
NO-Go to step 3.
3. Clear the DTC with the
DTC 12, 14, 16, 18: Wheel Sensor (Electrical
Noise/Intermittent Interruption)
NOTE:
If the ABS and other indicators come on because of
electrical noise, the indicators will go off when you
test-drive the vehicle at 10 mph (15 km/h) or more
and noise is gone.
An incorrectl
DTC 51: Motor Locked
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Test-drive the vehicle. Drive the vehicle at 10 mph
(15 km/h) or more, with the engine speed at
2,500 rpm or more.
4. Check fo
SEE MORE:
Interior Trim
Component Location Index
TAILGATE SIDE TRIM
Removal/Installation
TAILGATE UPPER TRIM
Removal/Installation
QUARTER PILLAR GLASS TRIM
Removal/Installation
REAR DOOR OPENING SEAL
Removal/Installation
B-PILLAR UPPER TRIM
Removal/Installation
FRONT DOOR OPENING SEA
Master Cylinder
Master Cylinder Replacement
NOTICE
Do not spill brake flu id on the vehicle; it may
damage the paint; if brake fluid gets on the paint,
wash it off immediately with water.
Be careful not to damage or deform the brake
lines during removal and installation.
To prevent the brake fluid from flo
© 2016-2025 Copyright www.hcrv.net
