Honda CR-V: Rear Differential

Special Tools

Honda CR-V. Rear Differential

Honda CR-V. Rear Differential

  1. Holder Handle
  2. Oil Seal Driver
  3. Attachment, 78 x 80 mm
  4. Attachment, 52 x 55 mm
  5. Companion Flange Holder
  6. Driver

Component Location Index

Honda CR-V. Rear Differential

READ NEXT:

 System Description

Outline The rear differential has a real-time 4WD control mechanism that enables 4WD by transmitting appropriate driving force from the front wheels to the rear wheels when necessary. It uses a real

 Dual Pump System Function Test

Starting and accelerating in forward gears (4WD mode) NOTE: Do not test repeatedly or the fluid will overheat. 1. Lift up the vehicle so all four wheels are off the ground. 2. Make a mark (A) on eit

 Rear Differential Fluid Inspection and Replacement

1. With the vehicle on level ground, inspect the differential fluid with the ignition switch turned to LOCK (0). 2. Use solvent and a brush to wash off any oil and dirt from the differential fluid in

SEE MORE:

 DTC 21-1x ("x" can be 0 thru 9 or A thru F): Open or Increased Resistance in Driver's Seat Belt Tensioner

DTC 21-1x ("x" can be 0 thru 9 or A thru F): Open or Increased Resistance in Driver's Seat Belt Tensioner Special Tools Required  SRS inflator simulator 07SAZ-TB4011A  SRS simulator lead K 070AZ-SNAA200 NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Proce

 Cylinder Head Installation

1. Install a new coolant separator in the engine block whenever the engine block is replaced. 2. Clean the cylinder head and block surface. 3. Install the new cylinder head gasket (A) and dowel pins (B) on the engine block. Always use a new cylinder head gasket. Set the crankshaft to top dead cen

© 2016-2026 Copyright www.hcrv.net