Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC 11, 13, 15, 17: Wheel Sensor (Open/Short to Body Ground/Short to Power)

1. Turn the ignition switch ON (II). 2. Check for DTCs with the HDS. Is DTC 87 indicated with DTC 11,13,15, and/or 17 at the same time? YES-Go to step 9. NO-Go to step 3. 3. Clear the DTC with the

 DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)

NOTE: If the ABS and other indicators come on because of electrical noise, the indicators will go off when you test-drive the vehicle at 10 mph (15 km/h) or more and noise is gone. An incorrectl

 DTC 51: Motor Locked

1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Test-drive the vehicle. Drive the vehicle at 10 mph (15 km/h) or more, with the engine speed at 2,500 rpm or more. 4. Check fo

SEE MORE:

 Turn Signal/Hazard Flasher

Component Location Index TURN SIGNAL SWITCH (Built into the combination light switch) TURN SIGNAL INDICATORS HAZARD WARNING SWITCH MICU (Built into the under-dash fuse/relay box) Circuit Diagram MICU Input Test NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. 1.

 A/C Condenser Fan High Speed Circuit Troubleshooting

NOTE: Do not use this troubleshooting procedure if the radiator fan and/or A/C compressor is inoperative. Refer to the symptom troubleshooting index. Before doing symptom troubleshooting, check for powertrain DTCs. 1. Check the No.6 (20 A) and No. 15 (7.5 A) fuses in the under-hood fuse/rela

© 2016-2026 Copyright www.hcrv.net