Honda CR-V: Symptom Troubleshooting

READ NEXT:

 Poor AM or FM radio reception or interference (with navigation)

NOTE: Check the radio reception in an open area. Compare it to a known-good vehicle of the same model, year, and trim level whenever possible. If necessary, have the customer demonstrate the sym

 Power switch will not turn ON (No information display and no sound) (with navigation)

1. With the ignition switch ON (II), push the power switch ON to see if navigation unit turns ON. Does the navigation unit display operate properly, and does the audio sound normal? YES-Intermittent

 No sound is heard from speaker(s) (display is normal) (with navigation)

NOTE: Set the fader and balance positions to the center. Before doing symptom troubleshooting, do the power switch will not turn ON troubleshooting. 1. Check that the volume button is not set to

SEE MORE:

 DTC P0731: Problem in 1st Clutch and 1st Clutch Hydraulic Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Warm up the engine to normal operating temperature (the radiator fan comes on). 2. Make sure that the transmission is filled to the proper level, and check for fluid

 Symptom Troubleshooting

Hard Steering 1. Check the power assist. Is the initial turning load more than 34 N (3.5 kgf, 7.7 Ibf) ? YES-Go to step 2. NO-Power assist is OK. 2. Connect the P/S joint adapter (pump), P/S joint adapter (hose), and P/S pressure gauge T/N 07406- 0010001 (see page 17-9), T/N 07406-001000A or T/N

© 2016-2025 Copyright www.hcrv.net