Honda CR-V manuals

Honda CR-V: Rear Differential

Honda CR-V (2006–2011) Service Manual / Transaxle / Rear Differential

Special Tools

Honda CR-V. Rear Differential

Honda CR-V. Rear Differential

  1. Holder Handle
  2. Oil Seal Driver
  3. Attachment, 78 x 80 mm
  4. Attachment, 52 x 55 mm
  5. Companion Flange Holder
  6. Driver

Component Location Index

Honda CR-V. Rear Differential

READ NEXT:

 System Description

Outline The rear differential has a real-time 4WD control mechanism that enables 4WD by transmitting appropriate driving force from the front wheels to the rear wheels when necessary. It uses a real

 Dual Pump System Function Test

Starting and accelerating in forward gears (4WD mode) NOTE: Do not test repeatedly or the fluid will overheat. 1. Lift up the vehicle so all four wheels are off the ground. 2. Make a mark (A) on eit

 Rear Differential Fluid Inspection and Replacement

1. With the vehicle on level ground, inspect the differential fluid with the ignition switch turned to LOCK (0). 2. Use solvent and a brush to wash off any oil and dirt from the differential fluid in

SEE MORE:

 DTC 83-26: No Signal From the Front Passenger's Weight Sensor (rear outer side)

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Read the DTC. Is DTC 83-26 indicated? YES-Go to step 3. NO-Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. 3. From INSPECTION m

 EGR Passage Removal and Installation

Removal 1. Drain the engine coolant. 2. Remove the air cleaner housing. 3. Remove the harness holder (A) from the bracket, then remove the harness holder bracket (B). 4. Remove the upper radiator hose (A), heater hose (B), and water bypass hose (C). 5. Remove the air cleaner housing brackets. 6

© 2016-2025 Copyright www.hcrv.net