Honda CR-V: Rear Differential
Honda CR-V (2006–2011) Service Manual / Transaxle / Rear Differential
Special Tools
- Holder Handle
- Oil Seal Driver
- Attachment, 78 x 80 mm
- Attachment, 52 x 55 mm
- Companion Flange Holder
- Driver
Component Location Index
- REAR DIFFERENTIAL MOUNT
- Replacement
- REAR DIFFERENTIAL ASSEMBLY
- Removal
- Disassembly
- Reassembly
- Installation
- REAR DIFFERENTIAL FLUID
- Inspection
- Replacement
- System Description
- Dual Pump System Function Test
- Rear Differential Fluid Inspection and Replacement
- Differential Disassembly
- Differential Reassembly
- Differential Mount Replacement
READ NEXT:
System Description
Outline
The rear differential has a real-time 4WD control mechanism that enables 4WD
by transmitting appropriate driving
force from the front wheels to the rear wheels when necessary. It uses a
real
Dual Pump System Function Test
Starting and accelerating in forward gears
(4WD mode)
NOTE: Do not test repeatedly or the fluid will overheat.
1. Lift up the vehicle so all four wheels are off the ground.
2. Make a mark (A) on eit
Rear Differential Fluid Inspection and
Replacement
1. With the vehicle on level ground, inspect the
differential fluid with the ignition switch turned to
LOCK (0).
2. Use solvent and a brush to wash off any oil and dirt
from the differential fluid in
SEE MORE:
Torque Converter Housing
Mainshaft Bearing and Oil Seal
Replacement
Special Tools Required
Adjustable bearing puller, 25-40 mm
07736-A01000B or 07736-A01000A
Attachment, 62 x 68 mm 07746-0010500
Attachment, 72 x 75 mm 07746-0010600
Driver 07749-0010000
1. Remove the mainshaft bearing and oil seal using
the adjustabl
Recirculation Control Motor
Circuit Troubleshooting
1. Check the No. 36 (10 A) fuse in the under-dash fuse/
relay box.
Is the fuse OK?
YES-Go to step 2.
NO-Replace the fuse, and recheck. If the fuse blows again, check for a short in
the No. 36 (10 A) fuse circuit.
2. Disconnect the recirculation control motor 7P
connector.
3. Turn the ignition s
© 2016-2025 Copyright www.hcrv.net
