Honda CR-V: Rear Differential
Honda CR-V (2006–2011) Service Manual / Transaxle / Rear Differential
Special Tools
- Holder Handle
- Oil Seal Driver
- Attachment, 78 x 80 mm
- Attachment, 52 x 55 mm
- Companion Flange Holder
- Driver
Component Location Index
- REAR DIFFERENTIAL MOUNT
- Replacement
- REAR DIFFERENTIAL ASSEMBLY
- Removal
- Disassembly
- Reassembly
- Installation
- REAR DIFFERENTIAL FLUID
- Inspection
- Replacement
- System Description
- Dual Pump System Function Test
- Rear Differential Fluid Inspection and Replacement
- Differential Disassembly
- Differential Reassembly
- Differential Mount Replacement
READ NEXT:
System Description
Outline
The rear differential has a real-time 4WD control mechanism that enables 4WD
by transmitting appropriate driving
force from the front wheels to the rear wheels when necessary. It uses a
real
Dual Pump System Function Test
Starting and accelerating in forward gears
(4WD mode)
NOTE: Do not test repeatedly or the fluid will overheat.
1. Lift up the vehicle so all four wheels are off the ground.
2. Make a mark (A) on eit
Rear Differential Fluid Inspection and
Replacement
1. With the vehicle on level ground, inspect the
differential fluid with the ignition switch turned to
LOCK (0).
2. Use solvent and a brush to wash off any oil and dirt
from the differential fluid in
SEE MORE:
Moonroof
If equipped
The moonroof can be tilted up in the
back for ventilation, or it can be slid
back into the roof. Use the switch on
the front ceiling to operate the
moonroof. You must turn the
ignition switch to the ON (II)
position to operate the moonroof.
To tilt up the moonroof, push
DTC 12, 14, 16, 18: Wheel Sensor (Electrical
Noise/Intermittent Interruption)
NOTE:
If the ABS and other indicators come on because of
electrical noise, the indicators will go off when you
test-drive the vehicle at 10 mph (15 km/h) or more
and noise is gone.
An incorrectly installed wheel bearing can cause one
of these DTCs.
1. Turn the ignition switch OFF.
2. Check
© 2016-2025 Copyright www.hcrv.net
