Honda CR-V: TPMS (Tire Pressure Monitoring System)
Component Location Index

- TPMS CONTROL UNIT
(Behind the dashboard center lower cover)
- TIRE PRESSURE SENSOR
- TIRE PRESSURE SENSOR
- UNDER-DASH FUSE/RELAY BOX
- TIRE PRESSURE SENSOR
- DATA LINK CONNECTOR (DLC)
- TIRE PRESSURE SENSOR
- UNDER-HOOD FUSE/RELAY BOX
READ NEXT:
System Indicator locations
The system has two indicators.
The low pressure indicator (A)
The TPMS indicator (B)
How TPMS Works
The TPMS (tire pressure monitoring system) has a low
pressure indica
Special Tools Required
TPMS sensor initializer tool AKS0620006
Available through the American Honda Tool and
Equipment program, 888-424-6857.
All four tire pressure sensor IDs must be memorized to
th
DTC 11, 13, 15, 17: Low Tire Pressure
NOTE: If low tire pressure is detected, the control unit
sets one or more of these DTCs, and turns on the low
pressure indicator. If the low pressure indicator co
SEE MORE:
NOTE: Information marked with an asterisk (*) applies
to the CANL line.
1. Turn the ignition switch OFF.
2. Jump the SCS line with the HDS.
3. Disconnect PCM connector A (44P), then disconnect
the HDS.
4. Measure resistance between PCM connector
terminals A36 and A37.
Is there about 95- 116 Ω
Check the fluid level in the brake
fluid reservoir monthly.
Replace the brake fluid according to
the maintenance messages shown on
the information display.
Always use Honda Heavy Duty
Brake Fluid DOT 3. If it is not
available, you should use only DOT 3
or DOT 4 fluid, from a sealed
c
© 2016-2026 Copyright www.hcrv.net
