Honda CR-V: Symptom Troubleshooting
Honda CR-V (2006–2011) Service Manual / Audio, Navigation,
and Telematics / Audio System / Symptom Troubleshooting
- Poor AM or FM radio reception or interference (with navigation)
- Power switch will not turn ON (No information display and no sound) (with navigation)
- No sound is heard from speaker(s) (display is normal) (with navigation)
- Audio system sound is weak or distorted (display is normal)
- XM radio display is blank and no station information is displayed
READ NEXT:
Poor AM or FM radio reception or
interference (with navigation)
NOTE:
Check the radio reception in an open area.
Compare it to a known-good vehicle of the same
model, year, and trim level whenever possible.
If necessary, have the customer demonstrate the
sym
Power switch will not turn ON (No
information display and no sound)
(with navigation)
1. With the ignition switch ON (II), push the power
switch ON to see if navigation unit turns ON.
Does the navigation unit display operate properly, and does the audio sound
normal? YES-Intermittent
No sound is heard from speaker(s) (display is
normal) (with navigation)
NOTE:
Set the fader and balance positions to the center.
Before doing symptom troubleshooting, do the
power switch will not turn ON troubleshooting.
1. Check that the volume button is not set to
SEE MORE:
Ignition System
Component Location Index
SPARK PLUG
Inspection
IGNITION COIL
Ignition Timing Inspection
Removal/Installation
Circuit Diagram
Ignition Timing Inspection
1. Connect the Honda Diagnostic System (HDS) to the
data link connector (DLC).
2. Turn the ignition switch
Hood
Hood Adjustment
1. Remove these items:
Front bulkhead cover
Front fender trim
Cowl cover
2. Slightly loosen each bolt (A).
3. Adjust the hood alignment in this sequence:
Adjust the hood right and left, as well as forward and rearward, by
using the elongated holes in the hood
hinges (B).
© 2016-2025 Copyright www.hcrv.net
