Honda CR-V: Rear Differential
Honda CR-V (2006–2011) Service Manual / Transaxle / Rear Differential
Special Tools
- Holder Handle
- Oil Seal Driver
- Attachment, 78 x 80 mm
- Attachment, 52 x 55 mm
- Companion Flange Holder
- Driver
Component Location Index
- REAR DIFFERENTIAL MOUNT
- Replacement
- REAR DIFFERENTIAL ASSEMBLY
- Removal
- Disassembly
- Reassembly
- Installation
- REAR DIFFERENTIAL FLUID
- Inspection
- Replacement
- System Description
- Dual Pump System Function Test
- Rear Differential Fluid Inspection and Replacement
- Differential Disassembly
- Differential Reassembly
- Differential Mount Replacement
READ NEXT:
System Description
Outline
The rear differential has a real-time 4WD control mechanism that enables 4WD
by transmitting appropriate driving
force from the front wheels to the rear wheels when necessary. It uses a
real
Dual Pump System Function Test
Starting and accelerating in forward gears
(4WD mode)
NOTE: Do not test repeatedly or the fluid will overheat.
1. Lift up the vehicle so all four wheels are off the ground.
2. Make a mark (A) on eit
Rear Differential Fluid Inspection and
Replacement
1. With the vehicle on level ground, inspect the
differential fluid with the ignition switch turned to
LOCK (0).
2. Use solvent and a brush to wash off any oil and dirt
from the differential fluid in
SEE MORE:
Intermediate Shaft
Intermediate Shaft Removal
1. Drain the automatic transmission fluid. Reinstall the drain plug with a
new washer.
2. Remove the right driveshaft.
3. Remove the flange bolt (A) and two dowel bolts (B).
4. Remove the intermediate shaft (A) from the
differential. Hold the intermediate shaft horizon
Idle Control System
Component Location Index
POWER STEERING PRESSURE (PSP) SWITCH
Signal Circuit Troubleshooting
A/C COMPRESSOR
CLUTCH RELAY
(RELAY SOCKET A)
Signal Circuit Troubleshooting
POWERTRAIN CONTROL
MODULE (PCM)
General Troubleshooting Information
Replacement
A/C
© 2016-2025 Copyright www.hcrv.net
