Honda CR-V: Rear Differential

Special Tools

Honda CR-V. Rear Differential

Honda CR-V. Rear Differential

  1. Holder Handle
  2. Oil Seal Driver
  3. Attachment, 78 x 80 mm
  4. Attachment, 52 x 55 mm
  5. Companion Flange Holder
  6. Driver

Component Location Index

Honda CR-V. Rear Differential

READ NEXT:

 System Description

Outline The rear differential has a real-time 4WD control mechanism that enables 4WD by transmitting appropriate driving force from the front wheels to the rear wheels when necessary. It uses a real

 Dual Pump System Function Test

Starting and accelerating in forward gears (4WD mode) NOTE: Do not test repeatedly or the fluid will overheat. 1. Lift up the vehicle so all four wheels are off the ground. 2. Make a mark (A) on eit

 Rear Differential Fluid Inspection and Replacement

1. With the vehicle on level ground, inspect the differential fluid with the ignition switch turned to LOCK (0). 2. Use solvent and a brush to wash off any oil and dirt from the differential fluid in

SEE MORE:

 DTC P0712: Short in ATF Temperature Sensor Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission. 1. Check the ATF temperature sensor voltage

 Water Passage Replacement

1. Drain the engine coolant. 2. Remove the alternator. 3. Remove the condenser fan shroud assembly. 4. Remove the A/C compressor without disconnecting the A/C hoses (see step 34). 5. Remove the intake manifold. 6. Remove the bolt (A) securing the connecting pipe. 7. Remove the lower radiator h

© 2016-2025 Copyright www.hcrv.net