Honda CR-V: Rear Differential
Honda CR-V (2006–2011) Service Manual / Transaxle / Rear Differential
Special Tools
- Holder Handle
- Oil Seal Driver
- Attachment, 78 x 80 mm
- Attachment, 52 x 55 mm
- Companion Flange Holder
- Driver
Component Location Index
- REAR DIFFERENTIAL MOUNT
- Replacement
- REAR DIFFERENTIAL ASSEMBLY
- Removal
- Disassembly
- Reassembly
- Installation
- REAR DIFFERENTIAL FLUID
- Inspection
- Replacement
- System Description
- Dual Pump System Function Test
- Rear Differential Fluid Inspection and Replacement
- Differential Disassembly
- Differential Reassembly
- Differential Mount Replacement
READ NEXT:
System Description
Outline
The rear differential has a real-time 4WD control mechanism that enables 4WD
by transmitting appropriate driving
force from the front wheels to the rear wheels when necessary. It uses a
real
Dual Pump System Function Test
Starting and accelerating in forward gears
(4WD mode)
NOTE: Do not test repeatedly or the fluid will overheat.
1. Lift up the vehicle so all four wheels are off the ground.
2. Make a mark (A) on eit
Rear Differential Fluid Inspection and
Replacement
1. With the vehicle on level ground, inspect the
differential fluid with the ignition switch turned to
LOCK (0).
2. Use solvent and a brush to wash off any oil and dirt
from the differential fluid in
SEE MORE:
Stabilizer
Stabilizer Link Removal/Installation
1. Raise the front of the vehicle, and support it with safety stands in the
proper locations.
2. Remove the front wheel.
3. Remove the flange nuts while holding the
respective joint pin (A) with a hex wrench (B), then
remove the stabilizer link (C).
4. Inst
Road Test
1. Warm up the engine to normal operating temperature (the radiator fan comes
on).
2. Apply the parking brake, and block both rear
wheels. Start the engine, then shift to the D position
while pressing the brake pedal. Press the
accelerator pedal, and release it suddenly. The
engine should not stal
© 2016-2025 Copyright www.hcrv.net
