Honda CR-V: DTC Troubleshooting
- DTC P0107: Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage Input
- DTC P0705: Short in Transmission Range Switch Circuit (Multiple Shift-Position Input)
- DTC P0706: Open in Transmission Range Switch Circuit
- DTC P0712: Short in ATF Temperature Sensor Circuit
- DTC P0716: Problem in Input Shaft (Mainshaft) Speed Sensor Circuit
- DTC P0721: Problem in Output Shaft (Countershaft) Speed Sensor Circuit
- DTC P0731: Problem in 1st Clutch and 1st Clutch Hydraulic Circuit
- DTC P0752: Shift Solenoid Valve A Stuck ON
- DTC P0776: A/T Clutch Pressure Control Solenoid Valve B Stuck OFF
- DTC P0962: Problem in A/T Clutch Pressure Control Solenoid Valve A Circuit
- DTC P0973: Short in Shift Solenoid Valve A Circuit
- DTC P16CO: PCM A/T Control System Incomplete Update
- DTC P2122: Accelerator Pedal Position (APP) Sensor A (Throttle Position Sensor D) Circuit Low Voltage Input
READ NEXT:
DTC P0107: Manifold Absolute Pressure
(MAP) Sensor Circuit Low Voltage Input
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
1. Clear the DTC with the HDS.
2. Turn the ignition switch OFF, then
DTC P0705: Short in Transmission Range
Switch Circuit (Multiple Shift-Position Input)
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
This code is caused by an electrical circuit problem
and cannot b
DTC P0706: Open in Transmission Range
Switch Circuit
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
This code is caused by an electrical circuit problem
and cannot b
SEE MORE:
Removing a Disc
To remove a disc from the audio unit,
fold back the screen by pressing the
OPEN button. Press
the disc eject button (
) to
remove the disc. If you eject the disc,
but do not remove it from the slot,
the system will automatically reload
it after 10 seconds and put it in pause
mode.
Wiper Blades
Check the condition of the wiper
blades at least every six months.
Replace them if you find signs of
cracking in the rubber, areas that are
getting hard, or if they leave streaks
and unwiped areas when used.
To replace a front wiper blade:
1. Raise each wiper arm off the
windshield, l
© 2016-2025 Copyright www.hcrv.net
