Honda CR-V: DTC Troubleshooting
- DTC P0107: Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage Input
- DTC P0705: Short in Transmission Range Switch Circuit (Multiple Shift-Position Input)
- DTC P0706: Open in Transmission Range Switch Circuit
- DTC P0712: Short in ATF Temperature Sensor Circuit
- DTC P0716: Problem in Input Shaft (Mainshaft) Speed Sensor Circuit
- DTC P0721: Problem in Output Shaft (Countershaft) Speed Sensor Circuit
- DTC P0731: Problem in 1st Clutch and 1st Clutch Hydraulic Circuit
- DTC P0752: Shift Solenoid Valve A Stuck ON
- DTC P0776: A/T Clutch Pressure Control Solenoid Valve B Stuck OFF
- DTC P0962: Problem in A/T Clutch Pressure Control Solenoid Valve A Circuit
- DTC P0973: Short in Shift Solenoid Valve A Circuit
- DTC P16CO: PCM A/T Control System Incomplete Update
- DTC P2122: Accelerator Pedal Position (APP) Sensor A (Throttle Position Sensor D) Circuit Low Voltage Input
READ NEXT:
DTC P0107: Manifold Absolute Pressure
(MAP) Sensor Circuit Low Voltage Input
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
1. Clear the DTC with the HDS.
2. Turn the ignition switch OFF, then
DTC P0705: Short in Transmission Range
Switch Circuit (Multiple Shift-Position Input)
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
This code is caused by an electrical circuit problem
and cannot b
DTC P0706: Open in Transmission Range
Switch Circuit
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
This code is caused by an electrical circuit problem
and cannot b
SEE MORE:
Sunglasses Holder
To open the sunglasses holder, push
then release the raised detent. It will
unlatch and swing down. To close it,
push it until it latches. Make sure the
holder is closed while you are driving.
Some larger styles of sunglasses
may not fit in the holder.
You may also store small it
Instrument Panel Brightness
You can change the instrument panel
brightness only when the light
switch is on.
Turn the knob on the lower part of
the instrument panel to adjust the
brightness.
You will hear a beep when maximum
or minimum brightness is reached.
To reduce glare at night, the
instrument panel
© 2016-2025 Copyright www.hcrv.net
