Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0107: Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage Input

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Clear the DTC with the HDS. 2. Turn the ignition switch OFF, then

 DTC P0705: Short in Transmission Range Switch Circuit (Multiple Shift-Position Input)

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot b

 DTC P0706: Open in Transmission Range Switch Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot b

SEE MORE:

 Rear Door

Rear Door Panel Removal/Installation Special Tools Required KTC trim tool set SOJATP2014 * Trim pad remover, Snap-on A 177 A or equivalent, commercially available * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Use the appropriate tool from the KTC

 Wipers/Washers

Component Location Index WINDSHIELD WIPER BLADES WIPER/WASHER SWITCH WINDSHIELD WIPER ARMS and LINK WINDSHIELD WIPER MOTOR UNDER-DASH FUSE/RELAY BOX UNDER-HOOD FUSE/RELAY BOX INTERMITTENT WIPER RELAY CIRCUIT (Built into the MICU) REAR WIPER BLADE REAR WIPER ARM REAR WINDOW WIPER MOT

© 2016-2025 Copyright www.hcrv.net