Honda CR-V: Rear Differential
Honda CR-V (2006–2011) Service Manual / Transaxle / Rear Differential
Special Tools
- Holder Handle
- Oil Seal Driver
- Attachment, 78 x 80 mm
- Attachment, 52 x 55 mm
- Companion Flange Holder
- Driver
Component Location Index
- REAR DIFFERENTIAL MOUNT
- Replacement
- REAR DIFFERENTIAL ASSEMBLY
- Removal
- Disassembly
- Reassembly
- Installation
- REAR DIFFERENTIAL FLUID
- Inspection
- Replacement
- System Description
- Dual Pump System Function Test
- Rear Differential Fluid Inspection and Replacement
- Differential Disassembly
- Differential Reassembly
- Differential Mount Replacement
READ NEXT:
System Description
Outline
The rear differential has a real-time 4WD control mechanism that enables 4WD
by transmitting appropriate driving
force from the front wheels to the rear wheels when necessary. It uses a
real
Dual Pump System Function Test
Starting and accelerating in forward gears
(4WD mode)
NOTE: Do not test repeatedly or the fluid will overheat.
1. Lift up the vehicle so all four wheels are off the ground.
2. Make a mark (A) on eit
Rear Differential Fluid Inspection and
Replacement
1. With the vehicle on level ground, inspect the
differential fluid with the ignition switch turned to
LOCK (0).
2. Use solvent and a brush to wash off any oil and dirt
from the differential fluid in
SEE MORE:
Seat Heaters
If equipped
Both front seats are equipped with
seat heaters. The passenger seat
only has heaters in the seat bottom
because of the side airbag cutoff
system.
The ignition switch must be in the
ON (II) position to use the heaters.
Push the top of the switch, HI, to
rapidly heat
Propeller Shaft
Propeller Shaft Inspection
Universal Joint and Boots
1. Set the parking brake, then shift the transmission to
the N position.
2. Raise the vehicle on a lift.
3. Check the center support bearing (A) for excessive
play or rattle. If the center support has excessive
play or rattle, replace the propel
© 2016-2025 Copyright www.hcrv.net
