Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0107: Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage Input

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Clear the DTC with the HDS. 2. Turn the ignition switch OFF, then

 DTC P0705: Short in Transmission Range Switch Circuit (Multiple Shift-Position Input)

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot b

 DTC P0706: Open in Transmission Range Switch Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot b

SEE MORE:

 DTC P2270/P2271: Secondary HO2S (Sensor 2) Circuit Signal Stuck Lean/Rich

DTC P2270: Secondary HO2S (Sensor 2) Circuit Signal Stuck Lean DTC P2271: Secondary HO2S (Sensor 2) Circuit Signal Stuck Rich NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2

 Relay and Control Unit Locations

Engine Compartment VSA MODULATOR-CONTROL UNIT AUXILIARY UNDER-HOOD RELAY BOX POWER MIRROR DEFOGGER RELAY PCM RADIATOR FAN RELAY ELECTRONIC THROTTLE CONTROL SYSTEM (ETCS) CONTROL RELAY ELD UNIT PGM-FI MAIN RELAY 1 (FI MAIN) UNDER-HOOD FUSE/RELAY BOX FAN CONTROL RELAY BLOWER MOTOR RELAY

© 2016-2025 Copyright www.hcrv.net