Honda CR-V: DTC Troubleshooting
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Electronic Throttle Control System / DTC Troubleshooting
- DTC P0122: TP Sensor A Circuit Low Voltage
- DTC P1658: ETCS Control Relay ON Malfunction
- DTC P1683: Throttle Valve Default Position Spring Performance Problem
- DTC P2101: Electronic Throttle Control System (ETCS) Malfunction
- DTC P2122: APP Sensor A (Throttle Position Sensor D) Circuit Low Voltage
- DTC P2135: TP Sensor A/B Voltage Incorrect Correlation
READ NEXT:
DTC P0122: TP Sensor A Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HD
DTC P1658: ETCS Control Relay ON
Malfunction
NOTE: Before you troubleshoot. record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Do the ETCS TEST in the
DTC P1683: Throttle Valve Default Position
Spring Performance Problem
CAUTION
Do not insert your fingers into the installed throttle
body when you turn the ignition switch ON (II) or
while the ignition switch is ON (II). If you do, you
will seriously injure your fingers
SEE MORE:
Voice Control System
You can select the AUX mode by
using the navigation system voice
control buttons, but cannot operate
the play mode functions.
iPods compatible with your audio
system using the USB adapter cable
are:
Use only compatible iPods with the
latest software. iPods that are not
compatible
F-CAN Circuit Troubleshooting
NOTE: Information marked with an asterisk (*) applies
to the CANL line.
1. Turn the ignition switch OFF.
2. Jump the SCS line with the HDS.
3. Disconnect PCM connector A (44P), then disconnect
the HDS.
4. Measure resistance between PCM connector
terminals A36 and A37.
Is there about 95- 116 Ω
© 2016-2025 Copyright www.hcrv.net
