Honda CR-V: Electronic Throttle Control System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Electronic Throttle Control System
Component Location Index
- ELECTRONIC THROTTLE
CONTROL SYSTEM (ETCS)
CONTROL RELAY (RELAY SOCKET F) - POWERTRAIN CONTROL
MODULE (PCM)
- General Troubleshooting Information
- Replacement
- THROTTLE ACTUATOR and THROTTLE POSITION (TP) SENSOR
-
ACCELERATOR PEDAL MODULE
-
Removal/Installation
-
-
ACCELERATOR PEDAL POSITION (APP) SENSOR
-
Signal Inspection
-
READ NEXT:
DTC P0122: TP Sensor A Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HD
DTC P1658: ETCS Control Relay ON
Malfunction
NOTE: Before you troubleshoot. record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Do the ETCS TEST in the
SEE MORE:
A/T Differential
Component Location Index
4WD
2WD
Backlash Inspection
NOTE: The illustration shows the 4WD model; 2WD is
similar.
1. Install the drive shaft and intermediate shaft into
the differential assembly.
2. Secure the driveshaft (A) in a bench vise (B) with
soft jaws (C). To prevent damage to the drivesh
DTC P2227: BARD Sensor Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P0101, P0108, P1128, and/or P1129 are stored
at the same time as DTC P2221, troubleshoot those
DTCs first, then recheck for DTC P2221.
1. Turn the ignit
© 2016-2025 Copyright www.hcrv.net
