Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0443: EVAP Canister Purge Valve Circuit Malfunction

Special Tools Required Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A or equivalent, commercially available. NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and revie

 DTC P0451: FTP Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P2422 is stored at the same time as DTC P0451, trouble

 DTC P0453: FTP Sensor Circuit High Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the H

SEE MORE:

 ATF Temperature Sensor

ATF Temperature Sensor Test/Replacement 1. Raise the vehicle on a lift, or apply the parking brake, block the rear wheels, and raise the front of the vehicle. Make sure it is securely supported. 2. Remove the splash shield. 3. Disconnect the shift solenoid harness connector. 4. Measure the ATF te

 Master Cylinder

Master Cylinder Replacement NOTICE Do not spill brake flu id on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water. Be careful not to damage or deform the brake lines during removal and installation. To prevent the brake fluid from flo

© 2016-2025 Copyright www.hcrv.net