Honda CR-V: Wipers/Washers

Component Location Index

Honda CR-V. Wipers/Washers

Honda CR-V. Wipers/Washers

Honda CR-V. Wipers/Washers

Honda CR-V. Wipers/Washers

Circuit Diagram - Windshield

Honda CR-V. Wipers/Washers

Circuit Diagram - Rear Window

Honda CR-V. Wipers/Washers

READ NEXT:

 DTC Troubleshooting

DTC B1028: Rear Window Wiper Motor (As) Signal Error NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. 1. Clear the DTCs with th

 MICU Input Test

1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and check the No.8 (10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay box. 2. Disconnect under-dash

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch.

SEE MORE:

 DTC P0721: Problem in Output Shaft (Countershaft) Speed Sensor Circuit

DTC P0721: Problem in Output Shaft (Countershaft) Speed Sensor Circuit DTC P0722: Problem in Output Shaft (Countershaft) Speed Sensor Circuit (No Signal Input) NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This c

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch. 4. Inspect the connector terminals to be sure they are all making good contact. If the terminals a

© 2016-2025 Copyright www.hcrv.net