Honda CR-V: To Play a Disc

To load or play discs, the ignition switch must be in the ACCESSORY (I) or ON (II) position.

You operate the disc changer with the same controls used for the radio.

To select the disc changer, press the CD button (CD/AUX button on models with satellite radio), the disc and track numbers are displayed.

The system will continuously play a disc until you change modes.

Do not use discs with adhesive labels.

Do not use discs with adhesive labels.

The label can curl up and cause the disc to jam in the unit.

This audio system can also play CD-Rs and CD-RWs compressed in MP3 or WMA formats. The numbers of the folder and track playing are shown in the display on the disc player. A disc can support up to 255 folders, and each folder can hold up to 255 playable files. A disc can hold up to 999 files in total.

When there are more than 99 folders in a disc, the audio display only shows two digits.

NOTE:

If a file on an MP3 or WMA disc is protected by digital rights management (DRM), the audio unit displays UNSUPPORTED, and then skips to the next file.

Video CDs and DVDs do not work in this unit.

The specifications for compatible MP3 files are:
Sampling frequency:
32/44.1/48 kHz (MPEG1)
16/22.05/24 kHz (MPEG2)
Bitrate:
32/40/48/56/64/80/96/112/128/160/192/224/256/320 kbps (MPEG1)
8/16/24/32/40/48/56/64/80/96/112/128/160 kbps (MPEG2)
Compatible with variable bitrate and multi-session
Supported standards:
MPEG1 Audio Layer3
MPEG2 Audio Layer3
Number of layers (including ROOT): Over 8 layers

The specifications for compatible WMA files are:
Sampling frequency:
32/44.1/48 kHz
Bitrate:
48/64/80/96/128/160/192 kbps
Compatible with variable bitrate and multi-session
Supported standards:
WMA version 7/8/9
Number of layers (including ROOT): Over 8 layers

READ NEXT:

 Loading Discs in the In-dash Disc Changer

Your vehicle’s in-dash disc changer holds up to six discs. 1. Press the LOAD button until you hear a beep and see ‘‘LOAD’’ on the display. To load only one CD, press and release th

 Text Data Display Function

Each time you press the TITLE button, the display shows you the text, if the disc was recorded with text data. You can see the album, artist, and track name in the display. If a disc is rec

 To Change or Select Tracks/Files

You can use the SEEK button while a disc is playing to change tracks (files in MP3/WMA mode). In MP3/WMA mode, use the or button to select folders in the disc, and use the SEEK button to

SEE MORE:

 Rear Differential Fluid Inspection and Replacement

1. With the vehicle on level ground, inspect the differential fluid with the ignition switch turned to LOCK (0). 2. Use solvent and a brush to wash off any oil and dirt from the differential fluid inspection oil filler plug. 3. Remove the oil filler plug (A) and the sealing washer (B), then check

 Oil Pan Removal

1. If the engine is already out of the vehicle, go to step 20. 2. Raise the vehicle on the lift to full height. 3. Drain the engine oil. 4. Remove the front wheels. 5. Remove the splash shield (see step 21). 6. Disconnect the air fuel ratio (A/F) sensor connector and secondary heated oxygen sen

© 2016-2024 Copyright www.hcrv.net