Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0443: EVAP Canister Purge Valve Circuit Malfunction

Special Tools Required Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A or equivalent, commercially available. NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and revie

 DTC P0451: FTP Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P2422 is stored at the same time as DTC P0451, trouble

 DTC P0453: FTP Sensor Circuit High Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the H

SEE MORE:

 Multiplex Integrated Control System

Component Location Index GAUGE CONTROL MODULE Input Test Replacement IMMOBILIZER-KEYLESS CONTROL UNIT (Built in receiver) MICU (Built into the under-dash fuse/relay box) Input Test Replacement General Troubleshooting Information Troubleshooting CAN Circuit Related Problems NOT

 HVAC (Heating, Ventilation, and Air Conditioning)

Special Tools Backprobe set Component Location Index SERVICE VALVE (HIGH-PRESSURE SIDE) SERVICE VALVE (LOW-PRESSURE SIDE) EVAPORATOR CORE (Located-in the heater unit) RECEIVER/DRYER DESICCANT Replacement A/C CONDENSER Replacement Clutch Check Clutch Overhaul Thermal Prote

© 2016-2025 Copyright www.hcrv.net