Honda CR-V: VSA (Vehicle Stability Assist) System Components
Honda CR-V (2006–2011) Service Manual / Brakes / VSA (Vehicle Stability Assist) System Components
Component Location Index
- VSA MODULATOR-CONTROL UNIT
- Removal and Installation
- UNDER-HOOD FUSE/RELAY BOX
- DATA LINK CONNECTOR (DLC)
- STEERING ANGLE SENSOR
- Replacement
- VSA OFF SWITCH
- Test
- RIGHT-REAR WHEEL SENSOR
- Replacement
- HUB BEARING UNIT
(MAGNETIC ENCODER)
- Replacement
- LEFT-REAR WHEEL SENSOR
- Replacement
- HUB BEARING UNIT
(MAGNETIC ENCODER)
- Replacement
- UNDER-DASH FUSE/RELAY BOX
- LEFT-FRONT WHEEL SENSOR
- Replacement
- WHEEL BEARING
(MAGNETIC ENCODER)
- Replacement
- YAW RATE-LATERAL
ACCELERATION SENSOR
- Replacement
- RIGHT-FRONT WHEEL SENSOR
- Replacement
- WHEEL BEARING
(MAGNETIC ENCODER)
- Replacement
- General Troubleshooting Information
- System Description
- DTC Troubleshooting
- Symptom Troubleshooting
- Steering Angle Sensor Replacement
READ NEXT:
General Troubleshooting Information
System Indicator
This system has four indicators:
ABS indicator (A)
Brake system indicator (B)
VSA indicator (C)
VSA activation indicator (D)
When the system detects a problem, it will turn the
System Description
VSA Modulator-control Unit Inputs and Outputs for 46P Connector
System Outline
This system is composed of the VSA modulator-control unit, the wheel sensors,
the steering angle sensor, and the
yaw
SEE MORE:
DTC P0962: Problem in A/T Clutch Pressure
Control Solenoid Valve A Circuit
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review General
Troubleshooting Information (see page 14-4).
This code is caused by an electrical circuit problem
and cannot be caused by a mechanical problem in the
transmission.
1. Clear the DTC with the HD
Glove Box Removal/Installation
NOTE: Take care not to scratch the dashboard and
related parts.
1. Open the glove box (A), and detach the hook (B) of
the glove box damper. While holding the glove box,
release the glove box stop (C) on each side from
the dashboard by pushing them in.
2. Close the glove box (A), then remove the bo
© 2016-2026 Copyright www.hcrv.net
