Honda CR-V manuals

Honda CR-V: Idle Control System

Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Idle Control System

Component Location Index

Honda CR-V. Component Location Index

Honda CR-V. Component Location Index

READ NEXT:

 DTC Troubleshooting

DTC P0506: Idle Control System RPM Lower Than Expected NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the

 A/C Signal Circuit Troubleshooting

1. Start the engine, and let it idle. 2. Turn the blower switch on. 3. Turn the A/C switch on. 4. Check the A/C CLUTCH in the DATA LIST with the HDS. Does it indicate ON? YES-Go to step 5. 5. Check t

 PSP Switch Signal Circuit Troubleshooting

1. Start the engine, and let it idle. 2. Align the steering wheel straight ahead. 3. Check the PSP SWITCH in the DATA LIST with the HDS. Does it indicate ON? YES-Go to step 4. NO-Go to step 14. 4.

SEE MORE:

 Emissions Testing

Testing of Readiness Codes If you take your vehicle for an emissions test shortly after the battery has been disconnected or gone dead, it may not pass the test. This is because of certain ‘‘readiness codes’’ that must be set in the onboard diagnostics for the emissions systems

 Trim Removal/Installation

Trim Removal/Installation-Door Areas Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doin

© 2016-2025 Copyright www.hcrv.net