Honda CR-V: Engine Assembly
Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Assembly
- Engine Removal
- Engine Installation
- Side Engine Mount Replacement
- Transmission Mount Replacement
- Side Engine Mount Bracket Replacement
READ NEXT:
Engine Removal
Universal eyelet 07AAK-SNAA120
Engine hanger adapter VSB02C000015 *
Front subframe adapter VSB02C000016 *
CR-V engine hanger adapter VSB02C000032 *
Engine support hanger, A and Reds AAR-T-12566
Engine Installation
Special Tools Required
Universal eyelet 07 AAK-SNAA 120
Engine hanger adapter VSB02C000015 *
Front subframe adapter VSB02C000016 *
CR-V engine hanger adapter VSB02C000032 *
Engine support hanger
Side Engine Mount Replacement
1. Support the engine with a jack and wood block
under the oil pan.
2. Remove the power steering (P/S) fluid reservoir
from the holder.
3. Remove the upper torque rod.
4. Remove the ground cable (A
SEE MORE:
Cable Reel Replacement
Removal
1. Make sure the front wheels are aligned straight
ahead.
2. Disconnect the negative cable from the battery, and
wait at least 3 minutes.
3. Remove the driver's airbag.
4. Disconnect the connector (A) from the cable reel,
then remove the steering wheel bolt (B).
5. Confirm that the front
Door Lock
Door Lock Actuator Test
Driver's Door and Left Rear Door
1. Remove the door panel.
Front
Rear
2. Disconnect the 10P connector (A) from the actuator
(B).
NOTE: The illustration shows the driver's door.
3. Check the actuator operation by connecting power
and ground according to the table. To
© 2016-2026 Copyright www.hcrv.net
