Honda CR-V: Idle Control System
Component Location Index

- POWER STEERING PRESSURE (PSP) SWITCH
- Signal Circuit Troubleshooting
- A/C COMPRESSOR
CLUTCH RELAY
(RELAY SOCKET A)
- Signal Circuit Troubleshooting
- POWERTRAIN CONTROL
MODULE (PCM)
- General Troubleshooting Information
- Replacement
- A/C COMPRESSOR
- ALTERNATOR
- Signal Circuit Troubleshooting
- A/C PRESSURE SENSOR

- BRAKE PEDAL POSITION SWITCH
- Signal Circuit Troubleshooting
READ NEXT:
DTC P0506: Idle Control System RPM Lower
Than Expected
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the
1. Start the engine, and let it idle.
2. Turn the blower switch on.
3. Turn the A/C switch on.
4. Check the A/C CLUTCH in the DATA LIST with the
HDS.
Does it indicate ON?
YES-Go to step 5.
5. Check t
1. Start the engine, and let it idle.
2. Align the steering wheel straight ahead.
3. Check the PSP SWITCH in the DATA LIST with the
HDS.
Does it indicate ON?
YES-Go to step 4.
NO-Go to step 14.
4.
SEE MORE:
Component Location Index
WINDSHIELD WIPER BLADES
WIPER/WASHER SWITCH
WINDSHIELD WIPER
ARMS and LINK
WINDSHIELD WIPER MOTOR
UNDER-DASH FUSE/RELAY BOX
UNDER-HOOD FUSE/RELAY BOX
INTERMITTENT WIPER RELAY CIRCUIT
(Built into the MICU)
REAR WIPER BLADE
REAR WIPER ARM
REAR WINDOW WIPER MOT
If equipped
The moonroof can be tilted up in the
back for ventilation, or it can be slid
back into the roof. Use the switch on
the front ceiling to operate the
moonroof. You must turn the
ignition switch to the ON (II)
position to operate the moonroof.
To tilt up the moonroof, push
© 2016-2025 Copyright www.hcrv.net
