Honda CR-V: DTC Troubleshooting
- DTC P0443: EVAP Canister Purge Valve Circuit Malfunction
- DTC P0451: FTP Sensor Range/Performance Problem
- DTC P0453: FTP Sensor Circuit High Voltage
- DTC P0455/P0456: EVAP System Large Leak Detected/Very Small Leak Detected
- DTC P0457: EVAP System Leak Detected/Fuel Fill Cap Loose or Missing
READ NEXT:
DTC P0443: EVAP Canister Purge Valve
Circuit Malfunction
Special Tools Required
Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A
or equivalent, commercially available.
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and revie
DTC P0451: FTP Sensor Range/Performance
Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P2422 is stored at the same time as DTC P0451,
trouble
DTC P0453: FTP Sensor Circuit High Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the H
SEE MORE:
Brake Booster
Brake Booster Test
Functional Test
1. With the engine stopped, press the brake pedal several times to deplete
the vacuum reservoir, then press the brake pedal hard, and hold it for 15
seconds. If the brake pedal sinks, either the master cylinder is bypassing
internally, or the brake system is lea
Dual Pump System Function Test
Starting and accelerating in forward gears
(4WD mode)
NOTE: Do not test repeatedly or the fluid will overheat.
1. Lift up the vehicle so all four wheels are off the ground.
2. Make a mark (A) on either No.1 or No.2 propeller
shaft (B).
3. Start the engine, and let it run until it warms up (the
ra
© 2016-2026 Copyright www.hcrv.net
