Honda CR-V manuals

Honda CR-V: Engine Assembly

Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Assembly

READ NEXT:

 Engine Removal

Universal eyelet 07AAK-SNAA120 Engine hanger adapter VSB02C000015 * Front subframe adapter VSB02C000016 * CR-V engine hanger adapter VSB02C000032 * Engine support hanger, A and Reds AAR-T-12566

 Engine Installation

Special Tools Required Universal eyelet 07 AAK-SNAA 120 Engine hanger adapter VSB02C000015 * Front subframe adapter VSB02C000016 * CR-V engine hanger adapter VSB02C000032 * Engine support hanger

 Side Engine Mount Replacement

1. Support the engine with a jack and wood block under the oil pan. 2. Remove the power steering (P/S) fluid reservoir from the holder. 3. Remove the upper torque rod. 4. Remove the ground cable (A

SEE MORE:

 MICU Input Test

NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. 1. Turn the ignition switch OFF. 2. Disconnect the under-dash fuse/relay box connectors E, F, G, K, R, and T. NOTE: All connector views are wire side of female terminals. UNDER-DASH FUSE/RELAY BOX CONNECTOR E (42P) UNDER-D

 Oil Pump Overhaul

Exploded View Oil Pump Removal 1. Turn the crankshaft pulley so its top dead center (TDC) mark (A) lines up with the pointer (B). 2. Remove the oil pan. 3. Remove and discard the oil pump chain tensioner. 4. To hold the rear balancer shaft, insert a 6 mm pin driver (A) into the maintenance hole

© 2016-2026 Copyright www.hcrv.net