Honda CR-V manuals

Honda CR-V: Idle Control System

Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Idle Control System

Component Location Index

Honda CR-V. Component Location Index

Honda CR-V. Component Location Index

READ NEXT:

 DTC Troubleshooting

DTC P0506: Idle Control System RPM Lower Than Expected NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the

 A/C Signal Circuit Troubleshooting

1. Start the engine, and let it idle. 2. Turn the blower switch on. 3. Turn the A/C switch on. 4. Check the A/C CLUTCH in the DATA LIST with the HDS. Does it indicate ON? YES-Go to step 5. 5. Check t

 PSP Switch Signal Circuit Troubleshooting

1. Start the engine, and let it idle. 2. Align the steering wheel straight ahead. 3. Check the PSP SWITCH in the DATA LIST with the HDS. Does it indicate ON? YES-Go to step 4. NO-Go to step 14. 4.

SEE MORE:

 Connecting Rod Bearing Replacement

Rod Bearing Clearance Inspection 1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Remove the connecting rod cap and bearing half. 4. Clean the crankshaft rod journal and bearing half with a clean shop towel. 5. Place plastigage across the rod journal. 6. Reinstall the bearin

 Transfer Assembly Inspection/Removal/Installation

Transfer Assembly Inspection 1. Shift the transmission into the N position. 2. Raise the vehicle on a lift, and make sure it is supported securely. 3. Make a reference mark (A) across the propeller shaft (B) and the transfer companion flange (C). 4. Separate the propeller shaft from the transfer

© 2016-2026 Copyright www.hcrv.net