Honda CR-V: Front Suspension

READ NEXT:

 Knuckle/Hub/Wheel Bearing Replacement

Exploded View Special Tools Required Hub dis/assembly tool 07GAF-SD40100 Ball joint remover, 32 mm 07MAC-SL0A102 Ball joint remover, 28 mm 07MAC-SL0A202 Ball joint thread protector, 14 mm 071AF-

 Lower Ball Joint Replacement

Special Tools Required Ball joint remover, 32 mm 07MAC-SL0A 102 Ball joint thread protector, 14 mm 071AF-S3VA000 1. Remove the front wheel. 2. Remove the flange bolt and flange nuts from the lowe

 Stabilizer

Stabilizer Link Removal/Installation 1. Raise the front of the vehicle, and support it with safety stands in the proper locations. 2. Remove the front wheel. 3. Remove the flange nuts while holdi

SEE MORE:

 Fuel Pump Circuit Troubleshooting

If you suspect a problem with the fuel pump, check that the fuel pump actually runs; when it is on, you will hear some noise if you listen to the fuel fill port with the fuel f ill cap removed. The fuel pump should run for 2 seconds when the ignition switch is first turned on. If the fuel pump does

 Folding the Rear Seats Down

Each rear seat-back can be folded down separately to give more cargo room. With either of the outer seatbacks folded-down, you can still carry a passenger in the rear seat. With the center seat-back foldeddown, either outer seating position can be used. You can also fold up the left or

© 2016-2025 Copyright www.hcrv.net