Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0122: TP Sensor A Circuit Low Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HD

 DTC P1658: ETCS Control Relay ON Malfunction

NOTE: Before you troubleshoot. record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Do the ETCS TEST in the

 DTC P1683: Throttle Valve Default Position Spring Performance Problem

CAUTION Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II). If you do, you will seriously injure your fingers

SEE MORE:

 The Starter Operates Normally

In this case, the starter motor’s speed sounds normal, or even faster than normal, when you turn the ignition switch to the START (III) position, but the engine does not run. Are you using a properly coded key? An improperly coded key will cause the immobilizer system indicator in t

 Fuel Supply System

Component Location Index FUEL RAIL FUEL FEED LINE FUEL TANK FUEL TANK UNIT FUEL PUMP FUEL GAUGE SENDING UNIT FUEL PRESSURE REGULATOR FUEL FILTER FUEL FILL CAP FUEL FILL PIPE FUEL LINE/QUICK-CONNECT FITTING FUEL VAPOR LINE FUEL LINE/

© 2016-2026 Copyright www.hcrv.net