Honda CR-V: Fuel Supply System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Fuel Supply System
Component Location Index
-
FUEL RAIL
-
FUEL FEED LINE
-
FUEL TANK
-
FUEL TANK UNIT
-
FUEL PUMP
-
FUEL GAUGE SENDING UNIT
-
FUEL PRESSURE REGULATOR
-
FUEL FILTER
-
FUEL FILL CAP
-
FUEL FILL PIPE
-
FUEL LINE/QUICK-CONNECT FITTING
-
FUEL VAPOR LINE
-
FUEL LINE/QUICK-CONNECT FITTING
-
POWERTRAIN CONTROL MODULE (PCM)
-
PGM-FI MAIN RELAY 1
-
PGM-FI MAIN RELAY 2 (FUEL PUMP)
READ NEXT:
DTC Troubleshooting
DTC P0461: Fuel Level Sensor (Fuel Gauge
Sending Unit) Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshoo
Fuel Pump Circuit Troubleshooting
If you suspect a problem with the fuel pump, check that
the fuel pump actually runs; when it is on, you will hear
some noise if you listen to the fuel fill port with the fuel
f ill cap removed. The fu
Fuel Pressure Relieving
Before disconnecting fuel lines or hoses, relieve
pressure from the system by disabling the fuel pump
and then disconnecting the fuel tube/quick connect
fitting in the engine compartment.
With the HDS
SEE MORE:
Steering Column
Steering Column Removal and Installation
SRS components are located in this area. Review the
SRS component locations and the
precautions and procedures before
doing repairs or service.
Removal
NOTICE
Be careful not to pull the bracket (A) on the front side of
steering column out of its normal positi
A/C Compressor
Replacement
NOTE: Do not install an A/C compressor into a system
unless you are completely sure that the system is free
of contamination. Installing the A/C compressor into a
contaminated system can result in premature A/C
compressor failure.
1. If the A/C compressor is marginally operable, run
the engine at i
© 2016-2025 Copyright www.hcrv.net
