Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0443: EVAP Canister Purge Valve Circuit Malfunction

Special Tools Required Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A or equivalent, commercially available. NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and revie

 DTC P0451: FTP Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P2422 is stored at the same time as DTC P0451, trouble

 DTC P0453: FTP Sensor Circuit High Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the H

SEE MORE:

 Headliner Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. NOTE: Put on gloves to protect your hands. Use the appropriate tool from the KTC trim tool set to avoid damage when prying components. Take care not t

 DTC Troubleshooting

DTC B1000: Communication Bus Line Error (Bus-off) 1. Clear the DTCs with the HDS. 2. Turn the ignition switch OFF, and then back ON (II). 3. Wait for 6 seconds or more. 4. Check for DTCs with the HDS. Is DTCs B1000 and/or B1008 and B1011 indicated? YES-Go to step 5. NO-Intermittent failure, the

© 2016-2025 Copyright www.hcrv.net