Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0443: EVAP Canister Purge Valve Circuit Malfunction

Special Tools Required Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A or equivalent, commercially available. NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and revie

 DTC P0451: FTP Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P2422 is stored at the same time as DTC P0451, trouble

 DTC P0453: FTP Sensor Circuit High Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the H

SEE MORE:

 DTC 82-14: No Signal From the Front Passenger's Weight Sensor (front inner side)

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Read the DTC. Is DTC 82-14 indicated? YES-Go to step 3. NO-Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. 3. From the SRS INSPE

 DTC 91: VSA System

1. Check the brake system for leaks or mechanical problems. Is the brake system OK? (No brake fluid leakage, no air trapped in the brake system, no brake pads worn out.) YES-Go to step 2. NO-Repair the brake system, then recheck. 2. Turn the ignition switch ON (II). 3. Clear the DTC with the HDS

© 2016-2025 Copyright www.hcrv.net