Honda CR-V: PGM-FI System
Component Location Index

-
CAMSHAFT POSITION (CMP)
SENSOR B (EXHAUST)
-
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR
-
POWERTRAIN CONTROL
MODULE (PCM)
-
ELECTRICAL LOAD
DETECTOR (ELD)
(bottom of fuse/relay box)
-
A/F SENSOR
(LAF) RELAY
(RELAY SOCKET E)
-
IGNITION
COIL RELAY
(RELAY SOCKET B)
-
MASS AIR FLOW (MAF) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR
-
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 1
-
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 2
-
MANIFOLD ABSOLUTE
PRESSURE (MAP) SENSOR
-
KNOCK SENSOR
-
INJECTORS
-
CRANKSHAFT POSITION
(CKP) SENSOR
-
IGNITION
COIL

READ NEXT:
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the sa
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Check for poor connections or loose terminals at
ECT sensor 1/2
SEE MORE:
DTC P0716: Problem in Input Shaft
(Mainshaft) Speed Sensor Circuit
DTC P0717: Problem in Input Shaft
(Mainshaft) Speed Sensor Circuit (No Signal
Input)
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
This code is c
Low pressure indicator does not come on,
and no DTCs are stored
1. Turn the ignition switch ON (II).
2. Check the low pressure indicator for several
seconds when the ignition switch is turned ON (II).
Did the indicator come on and then go off?
YES-Go to step 3.
NO-Go to step 8.
3. Turn the ignit
© 2016-2025 Copyright www.hcrv.net
