Honda CR-V: Front Suspension
Honda CR-V (2006–2011) Service Manual / Suspension / Front Suspension
READ NEXT:
Knuckle/Hub/Wheel Bearing Replacement
Exploded View
Special Tools Required
Hub dis/assembly tool 07GAF-SD40100
Ball joint remover, 32 mm 07MAC-SL0A102
Ball joint remover, 28 mm 07MAC-SL0A202
Ball joint thread protector, 14 mm 071AF-
Lower Ball Joint Replacement
Special Tools Required
Ball joint remover, 32 mm 07MAC-SL0A 102
Ball joint thread protector, 14 mm 071AF-S3VA000
1. Remove the front wheel.
2. Remove the flange bolt and flange nuts from the
lowe
Stabilizer
Stabilizer Link Removal/Installation
1. Raise the front of the vehicle, and support it with safety stands in the
proper locations.
2. Remove the front wheel.
3. Remove the flange nuts while holdi
SEE MORE:
Side Engine Mount Replacement
1. Support the engine with a jack and wood block
under the oil pan.
2. Remove the power steering (P/S) fluid reservoir
from the holder.
3. Remove the upper torque rod.
4. Remove the ground cable (A), then remove the side
engine mount bracket (B).
5. Remove the side engine mount stiffener (A), th
Hydraulic Flow
Distribution of Hydraulic Pressure
As the engine turns, the ATF pump starts to operate. Automatic transmission
fluid (ATF) is drawn through the ATF
strainer (filter) and discharged into the hydraulic circuit. Then, ATF flowing
from the ATF pump becomes line pressure
that is regulated by the regula
© 2016-2026 Copyright www.hcrv.net
