Honda CR-V: DTC Troubleshooting
- DTC P0443: EVAP Canister Purge Valve Circuit Malfunction
- DTC P0451: FTP Sensor Range/Performance Problem
- DTC P0453: FTP Sensor Circuit High Voltage
- DTC P0455/P0456: EVAP System Large Leak Detected/Very Small Leak Detected
- DTC P0457: EVAP System Leak Detected/Fuel Fill Cap Loose or Missing
READ NEXT:
DTC P0443: EVAP Canister Purge Valve
Circuit Malfunction
Special Tools Required
Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A
or equivalent, commercially available.
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and revie
DTC P0451: FTP Sensor Range/Performance
Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P2422 is stored at the same time as DTC P0451,
trouble
DTC P0453: FTP Sensor Circuit High Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the H
SEE MORE:
Rear Door
Rear Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover, Snap-on A 177 A or equivalent,
commercially available
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
Use the appropriate tool from the KTC
CD, DVD, and PC Card Removal/Installation
If the display will not open, use this procedure to
manually open the display and remove the CD, DVD,
and/or the PC card.
1. Remove the navigation unit from the vehicle.
2. On the bench, carefully pull the display (A) straight
out (about 1/2 inch).
3. Fold down the display as shown in the diagram
© 2016-2025 Copyright www.hcrv.net
