Honda CR-V: Front Suspension
Honda CR-V (2006–2011) Service Manual / Suspension / Front Suspension
READ NEXT:
Knuckle/Hub/Wheel Bearing Replacement
Exploded View
Special Tools Required
Hub dis/assembly tool 07GAF-SD40100
Ball joint remover, 32 mm 07MAC-SL0A102
Ball joint remover, 28 mm 07MAC-SL0A202
Ball joint thread protector, 14 mm 071AF-
Lower Ball Joint Replacement
Special Tools Required
Ball joint remover, 32 mm 07MAC-SL0A 102
Ball joint thread protector, 14 mm 071AF-S3VA000
1. Remove the front wheel.
2. Remove the flange bolt and flange nuts from the
lowe
Stabilizer
Stabilizer Link Removal/Installation
1. Raise the front of the vehicle, and support it with safety stands in the
proper locations.
2. Remove the front wheel.
3. Remove the flange nuts while holdi
SEE MORE:
TPMS (Tire Pressure Monitoring System)
Component Location Index
TPMS CONTROL UNIT
(Behind the dashboard center lower cover)
Replacement
TIRE PRESSURE SENSOR
Replacement
TIRE PRESSURE SENSOR
Replacement
UNDER-DASH FUSE/RELAY BOX
TIRE PRESSURE SENSOR
Replacement
DATA LINK CONNECTOR (DLC)
TIRE PRESSURE SENS
DTC P2227: BARD Sensor Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P0101, P0108, P1128, and/or P1129 are stored
at the same time as DTC P2221, troubleshoot those
DTCs first, then recheck for DTC P2221.
1. Turn the ignit
© 2016-2025 Copyright www.hcrv.net
