Honda CR-V: PGM-FI System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / PGM-FI System
Component Location Index
-
CAMSHAFT POSITION (CMP) SENSOR B (EXHAUST)
-
OUTPUT SHAFT (COUNTERSHAFT) SPEED SENSOR
-
POWERTRAIN CONTROL MODULE (PCM)
-
ELECTRICAL LOAD DETECTOR (ELD) (bottom of fuse/relay box)
-
A/F SENSOR (LAF) RELAY (RELAY SOCKET E)
-
IGNITION COIL RELAY (RELAY SOCKET B)
-
MASS AIR FLOW (MAF) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR
-
ENGINE COOLANT TEMPERATURE (ECT) SENSOR 1
-
ENGINE COOLANT TEMPERATURE (ECT) SENSOR 2
-
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR
-
KNOCK SENSOR
-
INJECTORS
-
CRANKSHAFT POSITION (CKP) SENSOR
-
IGNITION COIL
-
DATA LINK CONNECTOR (DLC)
-
PGM-FI MAIN RELAY 2 (FUEL PUMP)
- DTC Troubleshooting
- F-CAN Circuit Troubleshooting
- DLC Circuit Troubleshooting
- Injector Replacement
- PCM Replacement
READ NEXT:
DTC P0101: MAF Sensor Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the sa
DTC P0111: IAT Sensor Circuit Range/Performance Problem
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Check for poor connections or loose terminals at
ECT sensor 1/2
SEE MORE:
ATF Level Check
NOTE: Keep all foreign particles out of the transmission.
1. Park the vehicle on the level ground.
2. Warm up the engine to normal operating
temperature (the radiator fan comes on), and turn
the engine off. Do not allow the engine to warm up
longer than the time it takes for the radiator fan to
com
Symptom Troubleshooting
Hard Steering
1. Check the power assist.
Is the initial turning load more than 34 N (3.5 kgf,
7.7 Ibf) ?
YES-Go to step 2.
NO-Power assist is OK.
2. Connect the P/S joint adapter (pump), P/S joint
adapter (hose), and P/S pressure gauge T/N 07406-
0010001 (see page 17-9), T/N 07406-001000A or T/N
© 2016-2025 Copyright www.hcrv.net
