Honda CR-V: PGM-FI System
Component Location Index

-
CAMSHAFT POSITION (CMP)
SENSOR B (EXHAUST)
-
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR
-
POWERTRAIN CONTROL
MODULE (PCM)
-
ELECTRICAL LOAD
DETECTOR (ELD)
(bottom of fuse/relay box)
-
A/F SENSOR
(LAF) RELAY
(RELAY SOCKET E)
-
IGNITION
COIL RELAY
(RELAY SOCKET B)
-
MASS AIR FLOW (MAF) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR
-
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 1
-
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 2
-
MANIFOLD ABSOLUTE
PRESSURE (MAP) SENSOR
-
KNOCK SENSOR
-
INJECTORS
-
CRANKSHAFT POSITION
(CKP) SENSOR
-
IGNITION
COIL

READ NEXT:
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the sa
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Check for poor connections or loose terminals at
ECT sensor 1/2
SEE MORE:
1. Support the engine with a jack and wood block
under the oil pan.
2. Remove the upper torque rod.
3. Remove the ground cable (A), then remove the side
engine mount bracket (B).
4. Install the side engine mount bracket, then loosely
tighten the new bolt and nut (C), and loosely tighten
the bolt
Removal
1. Disconnect the negative cable from the battery, and
wait at least 3 minutes before beginning work.
2. Remove the passenger's vent panel.
3. Remove the dashboard center upper panel.
4. Remove the access panel (see step 5).
5. Detach the hook of the glove box damper and
release the glov
© 2016-2026 Copyright www.hcrv.net
